View file File name : u12.conf Content :# U12-SANE Backend configuration file # # each device needs at least two lines: # - [usb] vendor-ID and product-ID # - device devicename # i.e. for Plustek (0x07B3) U1212 (0x0001) # [usb] 0x07B3 0x0001 # device /dev/usbscanner # or # device libusb:bbb:ddd # where bbb is the busnumber and ddd the device number # make sure that your user has access to /proc/bus/usb/bbb/ddd # # additionally you can specify some options # warmup, lOffOnEnd, lampOff # # For autodetection use # [usb] # device /dev/usbscanner # # or simply # [usb] # # or if you want a specific device but you have no idea about the # device node or you use libusb, simply set vendor- and product-ID # [usb] 0x07B3 0x0001 # device auto # # NOTE: autodetection is safe, as it uses the info it got # from the USB subsystem. If you're not using the # autodetection, you MUST have attached that device # at your USB-port, that you have specified... # [usb] # # options for the previous USB entry # # switch lamp off after xxx secs, 0 disables the feature option lampOff 300 # warmup period in seconds, 0 means no warmup option warmup 15 # 0 means leave lamp-status untouched, not 0 means switch off # on sane_close option lOffOnEnd 1 # # for adjusting the default gamma values # #option redGamma 1.5 #option greenGamma 1.5 #option blueGamma 1.5 #option grayGamma 1.5 # # and of course the device-name # device auto # # to define a new device, start with a new section: # [usb] #