View file File name : sharp.conf Content :# The options are only meaningful if the backend was # compiled with USE_FORK defined # # option buffersize: size of one buffer allocated as shared # memory for data transfer between the reader process # and the parent process # option buffers: number of these buffers # The minimum is 2 # option readqueue: number of queued read requests. This is # with the current SANE version (1.01) only useful for # Linux, since queued read requests are not supported # for other operating systems. # # For Linux, a value of 2 is recommended, at least if a # JX-250 is used. Bigger values are only a waste of memory. # # For other operationg systems, set this value to zero # # option stop_on_fsu_error: should be 0 or 1. If set to 0, # the "FSU light dispersion error" does not cause the abortion # of a scan. # # option default_scan_source: valid values are "auto", "fsu", "adf" # and "flatbed". For "auto", the backend will enable an ADF or # or FSU, if installed. # # global options: option buffers 4 option buffersize 131072 option readqueue 2 option stop_on_fsu_error 1 option default_scan_source auto # look for all devices with vendor ID "SHARP" and type "Scanner" scsi SHARP * Scanner # no options specific to these devices listed -> use global options /dev/scanner # options specific to /dev/scanner option buffers 6 option buffersize 262144 option readqueue 2 # example for another (Linux) device name: #/dev/sg1