Edit file File name : pixma.conf Content :# pixma.conf configuration for the sane pixma backend # # bjnp-timeout=5000 # Specify the timeout (in ms) to be used for all the folllowing # scanners. # May be specified multiple times. # The last value (if any) will be used for auto-detection # # define URI's of scanners (one per line) # This is only used for network scanners. # normally scanners will be detected by sending a broadcast # if this does not work under your OS, or if the scanners # are on a different subnet, configure your scanners URI here # # method must be bjnp # port number can normally be left out, port 8612 is used as default # The timeout parameter sets a timeout value for the scanner on # the same line # Example: # bjnp://myscanner.my.domain:8612 // uses the default 1000ms timeout # bjnp-timeout=5000 # bjnp://printer-1.pheasant.org // will use the 5000 ms timeout # bjnp://scanner.bad-network.org/timeout=1500 // timeout set to 1500 ms # bjnp-timeout=3000 // will be used for auto-detected scanners # Save