Edit file File name : libvirt-guests Content :# Customizations for the libvirt-guests.service systemd unit # URIs to check for running guests # example: URIS='default xen:///system vbox+tcp://host/system lxc:///system' #URIS=default # action taken on host boot # - start all guests which were running on shutdown are started on boot # regardless on their autostart settings # - ignore libvirt-guests init script won't start any guest on boot, however, # guests marked as autostart will still be automatically started by # libvirtd #ON_BOOT=start # Number of seconds to wait between each guest start. Set to 0 to allow # parallel startup. #START_DELAY=0 # action taken on host shutdown # - suspend all running guests are suspended using virsh managedsave # - shutdown all running guests are asked to shutdown. Please be careful with # this settings since there is no way to distinguish between a # guest which is stuck or ignores shutdown requests and a guest # which just needs a long time to shutdown. When setting # ON_SHUTDOWN=shutdown, you must also set SHUTDOWN_TIMEOUT to a # value suitable for your guests. #ON_SHUTDOWN=suspend # Number of guests will be shutdown concurrently, taking effect when # "ON_SHUTDOWN" is set to "shutdown". If Set to 0, guests will be shutdown one # after another. Number of guests on shutdown at any time will not exceed number # set in this variable. #PARALLEL_SHUTDOWN=0 # Number of seconds we're willing to wait for a guest to shut down. If parallel # shutdown is enabled, this timeout applies as a timeout for shutting down all # guests on a single URI defined in the variable URIS. If this is 0, then there # is no time out (use with caution, as guests might not respond to a shutdown # request). The default value is 300 seconds (5 minutes). #SHUTDOWN_TIMEOUT=300 # If non-zero, try to bypass the file system cache when saving and # restoring guests, even though this may give slower operation for # some file systems. #BYPASS_CACHE=0 # If non-zero, try to sync guest time on domain resume. Be aware, that # this requires guest agent with support for time synchronization # running in the guest. By default, this functionality is turned off. #SYNC_TIME=1 Save